Cartridge connector

Pinout

This diagram represents a view from the right side of the console, looking down into its connector. Pins 01-31 are closest to the front of the console and correspond to the front of the cartridge.

    SNES (front) | Cart  |  SNES (back)
                  _______
                 |       |
   SYSTEM CLK -> |01   32| <- /WRAMSEL
       EXPAND <> |02   33| <- REFRESH
          PA6 -> |03   34| <- PA7
         /PRD -> |04   35| <- /PWR
                 |_______|
                 |       |
          GND -- |05   36| -- GND
          A11 -> |06   37| <- A12
          A10 -> |07   38| <- A13
           A9 -> |08   39| <- A14
           A8 -> |09   40| <- A15
           A7 -> |10   41| <- A16
           A6 -> |11   42| <- A17
           A5 -> |12   43| <- A18
           A4 -> |13   44| <- A19
           A3 -> |14   45| <- A20
           A2 -> |15   46| <- A21
           A1 -> |16   47| <- A22
           A0 -> |17   48| <- A23
         /IRQ <- |18   49| <- /ROMSEL
           D0 <> |19   50| <> D4
           D1 <> |20   51| <> D5
           D2 <> |21   52| <> D6
           D3 <> |22   53| <> D7
          /RD -> |23   54| <- /WR
   CIC data 1 <> |24   55| <> CIC data 2
key CIC reset -> |25   56| -> CIC CLK
       /reset <> |26   57| <- PHI2
          +5V -- |27   58| -- +5V
                 |_______|
                 |       |
          PA0 -> |28   59| <- PA1
          PA2 -> |29   60| <- PA3
          PA4 -> |30   61| <- PA5
left audio in <- |31   62| -> right audio in
                 |_______|

Signal descriptions

• EXPAND: Connects to expansion port pin 24 and is pulled high.
• SYSTEM CLK: 21.47727 MHz system clock.
• PHI2: This is the CPU clock output. When this signal is high, this means only that the CPU bus address is in a stable state. For both reads and writes, data is only guaranteed or required to be valid at the falling edge of this signal. /RD, /WR, /PRD, and /PWR are normally used instead of this.
• A23..0, /RD, /RW: The CPU address bus, also known as the A bus.
• A23..16: Also known as bank address or BA7..0.
• /ROMSEL: Asserted when accessing ROM ($00-3F,80-BF:8000-FFFF, $40-7D,C0-FF:0000-FFFF). Also known as /CART.
• /WRAMSEL: Asserted when accessing work RAM ($00-3F,80-BF:0000-1FFF, $7E-7F:0000-FFFF).
• PA7..0: The peripheral address bus, also known as the B bus.
  • /PRD, /PWR Read and write control lines for this bus.
• D7..0: Data lines, shared between the CPU and peripheral buses.
• CIC CLK: Either 4 MHz or 3.072 MHz, depending on the console.